Pomoc Restore to Factory Default

mynior

Nowy użytkownik
Noobie
30 Marzec 2013
3
3
3
Tarnów
QNAP
Ethernet
100 Mbps
Witam.

Przez niedoczytanie zrobiłem Restore to Factory Default i teraz nie mam nic na dysku. Od kilkunastu godzin skanuję dysk w programie R-Linux z nadzieją że uda mi się odzyskać chociaż zdjęcia i dokumenty. Mam dysk 2TB i jestem dopiero w połowie skanowania.
Czy jest sens dalej czekac aż przeskanuje do końca czy bezpowrotnie staciłem wszystko ?
Może jest jakiś inny sposób aby cokolwiek odzyskać z dysku? Dysk wyciągnąłem z obudowy TS-112 i skanuję go poprzez stację dokującą.

Proszę o pomoc.


Pozdrawiam, mynior
 
Trzeba zrobić tłumaczenie tej funkcji na forum bo może być pomocna.

enable configuration reset switch When this function is turned on, you can press the reset button for 3 seconds to reset the administrator password and the system settings to default. The disk data will be retained.
System|Basic system reset
(1 beep)|Advanced system reset
(2 beeps)
\All NAS models|Press the reset button for 3 sec|Press the reset button for 10 sec
basic system reset (3 sec) After pressing the reset button for 3 seconds, a beep sound will be heard. The following settings will be reset to default:
  • System administration password: admin.
  • TCP/IP configuration: Obtain IP address settings automatically via DHCP.
  • TCP/IP configuration: Disable Jumbo Frame.
  • TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port trunking mode will be reset to “Active Backup (Failover)”.
  • System port: 8080 (system service port).
  • Security level: Low (Allow all connections).
  • LCD panel password: (blank)*.
  • VLAN will be disabled.
  • Service binding: All NAS services run on all available network interfaces.
*This feature is only provided by the NAS models with LCD panels. Please visit http://www.qnap.com for details.

advanced system reset (10 sec) After pressing the reset button for 10 seconds, you will hear two beeps at the third and the tenth seconds. The NAS will reset all the system settings to default as it does by the web-based system reset in “Administration” > “Restore to Factory Default” except all the data are reserved. The settings such as the users, user groups, and the network shares previously created will be cleared. To retrieve the old data after advanced system reset, create the same network shares on the NAS and the data will be accessible again.


@mynior wyżej podkreślone dotyczy Ciebie. Także zapinaj dysk do QNAP'a...[/information]
 
  • Lubię to
Reakcje: Paweł Tołoczko